MI 3101 EurotestAT: Appendix C
Locator receiver R10K
106
L
/L
1
N
/L
2
PE/L3
Mains supply
Lines: energized
Figure C.4: Transmitter as active load, clamp used instead of inductive sensor
C.1.3 Positioning selective probe
For searching a fuse in a group the selective probe shall be used. The wire or housing of
the fuse must be touched at the right angle with it. Find the best signal by rotating the
probe.
Keep the maximum distance between R10K and selective probe.
Note
:
Keep fingers behind the probe barrier to avoid electric shock and access of live
parts.
C.2 Detection distances for different connections
Connection
Distance up to
Connection between L and N wire in same wall socket
40 cm
Connection between L wire in one wall socket and N wire in
other wall socket with separated conduits*
2 m
* WARNING! Avoid connection of the EurotestAT in trace mode between line and PE of
different wall sockets, electric shock hazard!
C.3 R10K power supply
The receiver R10K is supplied by a 9 V alkaline battery (IEC 6LR61).
C.4 Maintenance
Remove battery from R10K when not in use for a longer time.
Apply maintenance instructions from chapter 7 of this document.
