Metos Muster 800, Руководство пользователя по установке и эксплуатации, Страница: 13 / 29

18.9.2007 Rev. 2.4
Installation
7
5. Installation
5.1 General
The automatic ice flake maker is delivered attached to a special wooden pallet and pro-
tected with cardboard packaging. Installation must be carried out exclusively by qualified
and authorized staff, in compliance with current national standards and following the
manufacturer’s instructions.
5.1.1 Using conditions
The best performance of the automatic ice flake maker is achieved at a room temperature
of 20ºC and a water supply temperature of 15ºC. You are advised to install the appliance
with a room temperature of between 10ºC and 35ºC, and a water supply temperature of
between 3ºC and 25ºC. Avoid installing the appliance where it may be exposed to direct
sunlight or near to heat sources, such as radiators, stoves, dish-washers, etc.
5.2 Possible disturbances from environment (to environment)
If installation is carried out incorrectly, damage and/or injury may ensue to the environ-
ment, persons, animals or things. The manufacturer declines all responsibility for any
such damage or injury.
5.3 Storage
The net weight and the weight including packaging of the ice flake maker are given on the
cover of the packaging. In order to prevent the oil contained in the compressor from flow-
ing into the coolant circuit, make sure to transport, store, and handle the automatic ice
flake maker always keeping it standing upright. Follow the instructions given on the pack-
aging.
The special wooden pallet, built so that it can be lifted with a fork-lift truck, enables the
appliance to be moved around using ordinary means of handling and lifting.
5.4 Preparing installation
Make sure, that the ice flake maker will be installed on an perfectly level. Avoid installing
the appliance near heat sources. A floor drain should be found near of the place of instal-
lation. The maximum distance being 5 m. Make sure that the meltwater pipe presents a
slope of at least 15 % throughout its entire length.