Metos 72/02CG, Инструкция по установке и эксплуатации

Страница: 23 / 72

2.9.2003 Rev. 1.0
Installation
17
5. Installation
5.1 General information
The manufacturer cannot be held liable for any damage to property or injury to persons
deriving from installation errors or from inappropriate use of the appliance and is not re-
sponsible for any faults caused by defective installation. In such cases, the warranty shall
be null and void.
The appliance should be installed, serviced, connected to the gas system, to the power
supply and started up only by an authorized installer, who must comply with the safety
regulations in force in the place where the appliance is being installed.
5.1.1 Regulatory installation conditions
For your information, we remind you that all appliances installed in public assembly
buildings must meet all the requirements listed below. The appliance should be both in-
stalled and serviced in accordance with all applicable regulations and standards in force,
namely:
• safety regulations on fire hazard and panic in public assembly buildings.
• general regulations applicable to all appliances;
• systems burning combustible gas and liquefied hydrocarbons.
Then, follow the specific regulations according to the type of gas being used.
• heating, ventilation, refrigeration, air conditioning, and generation of steam and
hot water for sanitary use;
• installation of foodservice cooking appliances;
• specific regulations applicable to each type of public assembly building (hospitals,
shops, etc.).
5.2 Exhausting fumes
The appliance should be installed in a well-ventilated area, if possible under a vent hood,
in compliance with all applicable regulations in force. This will ensure that all burnt gases
produced during the combustion process are completely exhausted. The amount of air re-
quired for combustion is shown in the
"Technical Specifications Table" at the end of this
manual, under "Air required for combustion".
In compliance with applicable installation regulations in force, our appliances belong to
the type shown under "Construction type" in the
"Technical specifications table" .