35
Footswitch
Use the Footswitch quick key page to assign keypad button commands to button #1, button #2, or
button #3 of the attached footswitch. To assign a footswitch button to a keypad button;
•
Select the “Footswitch” item from the Quick Keys settings menu.
•
Choose the Footswitch button number you would like to assign.
•
Press the “Assign” softkey.
•
A dialog will be displayed, “Press front panel key to assign.”. Press the keypad key that you
would like to assign to this footswitch button.
•
The same procedure can be repeated to configure footswitch button #2.
4.7
RS232
The “RS232” settings screen contains setup parameters for configuring the general purpose IO port for
on the Mx200 readout for serial data output. The port parameters configured on the Mx200 should
match that of the connected device(PC).
Note
: The general purpose IO port on the Mx200 is used for both serial data transfer and button input.
As such the wiring for the connection cable must be specific to the connection modes being used. Please
see the signal assignment diagram at the end of this section for reference.
RS232 Function
Description
Baud Rate
Configure Baud rate for connection. 110 through 115,200 can be
chosen using the appropriate softkey.
Parity
Configure the correct parity mode for the connection. Even/Odd/No
can be selected using the appropriate softkey.
Stop Bits
Configure the correct number of Stop Bits for the connection. 1 or 2
can be chosen using the appropriate softkey.
Send Labels
Specifies whether or not the coefficient label will be sent along with
the value. Set to Yes or No using the appropriate softkey.
