Meteor Matisse, Руководство пользователя

Страница: 35 / 49

29
Advanced Functions
Media Sensor Calibration
It is necessary to accomplish Media Sensor Calibration after a new roll
of media has been loaded.
1. Press and hold the Feed/Calibration button for about 4 seconds.
2. The printer will feed approximately 200mm of media;
3. The three indicators stop blinking and remain lit, the printer is back to
a normal state.
Self Test
1. Press and hold the Pause/Self Test button for about 4 seconds;
2. The printer will print out a configuration report and the three
indicators will stop blinking and remain lit. The printer is back to a
normal state.
3. The following information will be printed on the self-test report:
- Font list
- Hardware configuration and status
- DIP switch settings
- Label parameters
- Firmware version
Reset – Reset the Printer to the Factory Default Settings
Following the steps listed below allows you to reset the printer to the
factory default settings.
1. Press and hold the Cancel/ Reset button for 4 seconds, the three
lamps will blink simultaneously (the printer will return to normal
state automatically if no operations are performed within 4 seconds);
2. Release and press the Cancel/ Reset button again;
3. The three indicators stop blinking and remain lit. The printer is now in