Meteor Matisse, Руководство пользователя

Страница: 25 / 49

19
Loading the Media
Matisse printers can be operated in three different modes: Standard
mode, Peel-off mode, or Cutting mode.
-- In Standard mode, each printed label remains on the backing
liner.
-- In Peel-off mode, each printed label is peeled away from the
backing liner automatically.
-- In Cutting mode, the printer automatically cuts the label after it is
printed.
Standard Mode
1. Lift up the top cover to expose the media compartment (Figure 6-1).
2. Load a roll of media (labels facing up) on the Media Spindle, then
slide the two Media Roll Guides with their smooth sides toward the
media onto the Media Spindle from each end until snug against the
media. If you are placing a roll of media with a 3″ ID core, please
slide the two Core Adapters onto the Media Spindle first (Figure 6-2).
3. Insert them into the printer.
4. Corresponding to the scale on the Media Spindle, position the media
roll in the middle of the Spindle.
5. Release and lift the Printhead Module.
6. Route the media as shown in Figure 6-3.
7. Slide the Media Guide to the edge of the media.
8. Close the Printhead Module and press down until it locks into place
(Figure 6-4).
9. Close the cover and press the „Feed‟ button to feed the media and
ensure proper tracking. If the printer does not correctly sense the top
of each label, it may be necessary to perform the Calibration
Procedure in the Operation Basics section.