Metcalfe A300, Инструкция по эксплуатации и техническому обслуживанию

Страница: 8 / 14

8
USING THE MACHINE
Check that the slicer is properly connected to the electrical line and that the slice
thickness regulator is positioned on “0”.
The off button light must be on and you have to see one led on of the STROKE button
light.
Manual use:
•
Turn the function mode selector knob (11) counterclockwise;
•
Put the product to be sliced on the food plate (7) up to against the thickness gauge
plate (17) and block it;
•
Start the blade by pressing ON button.
•
Regulate the thickness of the slice as necessary (10) and start manual operation by
moving the carriage with the handle of the food plate (8).
•
Use the handle of the food press if the weight and the size of the product do not
allow a proper cutting.
Automatic use (push button control panel):
•
Turn the function mode selector knob (11) clockwise;
•
Put the product to be sliced on the food plate (7) up to against the thickness gauge
plate (17) and block it;
•
Start the blade pressing the ON button;
•
Regulate the thickness of the slice as necessary (10) and then start the food plate
carriage by pressing the SPEED button;
•
When you start the carriage movement there is only one led on for SPEED light, and
you can increase the speed pressing once or twice the SPEED button.
•
When you start the carriage movement there is only on led on for the STROKE light
and if you want to increase the carriage run you have to press once or twice the
STROKE button.
Note : when you push the OFF button, you stop the blade and the carriage movement.
But the slicer keeps the settings regarding speed and stroke, so when you push the ON
button the slicer restarts with the same carriage run and speed before the stopping.
If you want to stop the carriage movement, you can turn the function mode selector
knob (11) counterclockwise or you can press the SPEED button in order to have no led on
the lamp of the light speed.
You can return to the automatic mode turning again the function mode selector knob,
with the previous settings of speed and stroke.
Note : you can loose the settings only plugging off the electrical cable.
Warning : the circuit board has a thermal protector. If the circuit board reach the 80°C
temperature (if you use the slicer continuously for 4 hours without turning off, maybe it
could happen), the slicers turns off. So you have to plug off the electrical cable and you
can’t use it for 5 minutes. Then you can re-start top use it as written above.