Metcalfe A300, Инструкция по эксплуатации и техническому обслуживанию

Страница: 12 / 14

12
Sharpen the blade on models AUT.839 – AUT.849
Blade grinding must be carried out as soon
as a decrease in cutting capacity is
noticed.
Proceed as follows:
•
Check that the slicer is properly
connected to the electrical line and
that the slice thickness regulator is
positioned on “0” (must be ON the
light of OFF button);
•
Turn the function mode selector knob
(11)
counterclockwise (manual
mode);
•
Raise the cover (3);
•
Take out the knob (4) and push on it
turning the grinding device over and
brining the grinding wheels into the
grinding position;
•
Release the knob (4) hooking the
grinding device tightly;
•
Start the blade pressing ON button;
•
Sharpen the blade by pressing and
holding down the lever (5) for about
10 seconds so the grinding wheel is
working;
•
Press the lever (5) again for about 2-3
seconds to engage the trims grinding
wheel;
WARNING: do not trim too much so as
to avoid twisting the blade edge.
•
Stop the blade movement pressing ON
button;
•
Raise the locking knob (4) and turn
the grinding device over putting it
back into its original position;
•
Release the knob (4) and lower the
cover (3);
•
Clean the slicing machine.