12
OPERATION MANUAL
3.3 MACHINE LEVELING
To set your machine up so that it operates to optimum performance, apply the following
procedure
After your machine has been anchored to a concrete slab floor, it then needs to be leveled.
Loosen the hold down bolts and place a level on the surface of the working table. A metal plate
needs to be placed under corner of the base of the machine and the jacking screw adjusted
until level. Once level then tighten the hold down bolts. (Fig. 3.3).
The machine must not rest on supports
other than those defined in Fig. 3.3
F
ig
. 3.2
In some case a suitable foundation may not be available
and a new one may need to be prepared.
The foundation should be concrete approximately 200mm
thick with pockets left clear for the hold down bolts. The
hold down bolts can be “L” shape as per the example in
Fig. 3.2
F
ig
. 3.3
Hold Down Bolt
Metal Shim
22/07/2019
Instructions Manual for PB-422L (S576)
12
