Metallkraft 3860018, Руководство по эксплуатации

Страница: 11 / 18

Cleaning, maintenance and service/repair
GS 18 | Version 1.05 11
Step 7: Pull out mains plug and remove chips with a tool.
7.4 Depth stop
The depth stop is useful if you have to work a blind hole
or a through hole with an obstacle behind the hole. Of
course, the depth stop can be used for each threaded
hole. You can move the depth stop forwards or back-
wards or remove it when you do not need it.
Step 1: Loosen the locking screw of the depth stop and
set it so that it is flush with the end of the tap.
This will be their zero position.
Step 2: Subtract the desired depth of cut from this posi-
tion and additional 4 mm (due to internal me-
chanics). Set this from the zero position.
Step 3: Close the locking screw.
7.5 Safety clutch
The slip clutch is designed in such a way that when the
maximum torque is reached, the clutch slips over. This
is to protect against tearing of the tap and protect the
motor.
The slip clutch is pre-set at the factory and can be read-
justed if it changes in maximum torque. For this please
contact our customer service (see 1.2).
8 Cleaning, maintenance and service/
repair
8.1 Cleaning
NOTE!
Use the supplied depth stop to keep control over the
depth of cut.
Upforce:
Counterclockwise
Tips and recommendations
To ensure that the tapping power tool is always in
good operating condition, regular care and mainte-
nance work must be carried out.
WARNING!
Danger due to insufficient qualification of
persons!!
Insufficiently qualified personnel can not assess the
risks involved in maintenance work on the machine
and expose themselves and others to the risk of seri-
ous injury.
- All maintenance work should only be carried out by
qualified persons.
DANGER!
Danger to life due to electrical shock!
There is a danger to life when in contact with live
components.
- Always unplug the appliance before cleaning and
maintenance.
- Connections and repairs of the electrical equip-
ment may only be carried out by a qualified electri-
cian.
NOTE!
After servicing, maintenance and repair work, check
that all panels and guards are properly installed on
the machine again and that there is no more tools
inside or in the working area of the tapping power
tool.
Damaged safety devices and parts must be
repaired or replaced by the customer service.
NOTE!
Oil, grease and cleaning agents are hazardous to
the environment and must not be dumped into
wastewater or normal household waste. Dispose of
these funds in an environmentally friendly way. The
cloths soaked in oil, grease or detergent are easily
flammable. Collect the cleaning rags or cleaning
wool in a suitable, closed container and dispose of
them in a manner suitable for environmentally-
friendly disposal - do not dispose of with household
waste!