Metallkraft 3860018, Руководство по эксплуатации

Страница: 12 / 18

12 GS 18 | Version 1.05
Cleaning, maintenance and service/repair
Clean the machine after each use.
Do not remove metal or scrap with bare hands, but use
safety gloves to prevent cuts.
Clean all painted surfaces with a soft, damp cloth.
Never use solvents to clean plastic parts or painted sur-
faces. A surface release and consequential damage
may occur.
Keep the ventilation slots of the engine free from cont-
amination to ensure sufficient cooling.
8.2 Maintenance
Every 50 hours of operation, clean the engine with com-
pressed air during operation without load. Attention!
Wear eye protection.
Always keep the spindle shaft free of dirt and swarf. Lu-
bricate the spindle shaft regularly.
Changing the carbon brushes:
The carbon brushes are normal wear parts and must be
replaced as soon as they are worn.
Fig. 7:
Carbon brushes
Fig. 8: Change carbon brush
Step 1: Unscrew the four engine cover screws and re-
move the engine cover.
Step 2: Use needle-nose pliers to push the spring aside.
Step 3: Unscrew the connection cable of the carbon
brush and remove the carbon brush.
Step 4: Insert the new carbon brush into the holder and
assemble in reverse order.
Step 5: Follow these steps on both sides.
Step 6: Screw on the engine cover.
If the machine comes to an unexpected stop, check the
carbon brushes. Due to the automatic stop, the carbon
brushes are not sanded down to the end. This serves to
protect the engine.
8.3 Servicing
As a result of wear, it may happen that maintenance
work must be carried out on the machine.
Wearing Protective gloves!
Wearing Protective clothing!
Wearing Eye protection!
ATTENTION!
Always replace the carbon brushes in pairs.
ATTENTION!
Repairs or maintenance work may only be carried
out by qualified and trained specialist personnel.
Carbon brush
Carbon brush