Metal-Fach N 267, Инструкция по эксплуатации, каталог запасных частей

Страница: 22 / 31

22
6.4. Lubrication
Lubrication of the spreader systems in accordance with the lubrication schedule ensures
better performance and protects from premature wear.
Follow these rules when lubricating:
• before attempting to lubricate, thoroughly clean all grease nipples and areas around the
lubrication points from mud and dust;
• feed the grease into the nipple until the fresh grease flows out of the spaces between mating
parts;
• apply fresh grease on the land wheel bearings by first removing the wheels with the hubs –
then wash the hubs and pivots with Diesel fuel and fill the hub lubricating chambers with
fresh grease;
• replace the transmission gearbox oil directly after stopping the spreader (the oil temperature
will be higher, which facilitates draining it from the gearbox);
• flush the gearbox with Diesel fuel before priming with fresh oil;
•
lubricate the PTO drive-shafts in accordance with the shaft operating manual.
Perform the lubrication of the wheel bearing during the inspection and adjustment of the
brakes. When replacing the wheel hub bearings, remove all grease from the hub chambers.
After each year of operation, remove the hubs with their bearings, wash the bearings and the hub
chamber and then refill with fresh grease. The lubrication points are shown in the lubrication
diagrams.
All lubrication points indicated in yellow must be greased or checked for grease level before
starting the spreader. Use ŁT-42 , ŁT-43 or any other high-performance bearing grease. The
transmission gearboxes are primed with HIPOL 15 oil.