Metal-Fach N 267, Инструкция по эксплуатации, каталог запасных частей

Страница: 16 / 31

16
Optional accessories include an user-installed adapter kit that enables coupling with a single
hydraulic section of the tractor. The gate and the floor conveyor are simultaneously controlled
by a DCV attached to the spreader and controlled from inside of the cabin with Bowden cables.
To install the adapter kit:
1. Open the 4 hydraulic lines that couple the tractor with the spreader.
2. Screw the cable-actuated DCV (included with the kit) to the spreader.
3 Install a two-position catch (included with the kit) on the right hand spreader section that
controls the floor conveyor drive.
4. Connect the Bowden cables to the DCV.
5 Connect the 2 hydraulic lines between the DCV and the tractor (the inputs are at the DCV
sides).
6. Connect 4 hydraulic lines with the DCV section outputs (the lines which are connected
with the gate's steel lines on the spreader left hand side and with the conveyor speed
controller unit on the right hand side).
When in doubt, consult the spreader single-section hydraulic system diagram in the Spare
Parts Catalogue.
The design manure feed rate at the tractor PTO rotational speed of 540 rpm and the hydraulic
system pressure of 13 MPa can be infinitely variably adjusted from 0.2 to 1.3 m/min.
Note: Take extra caution when performing the adjustment. Turn off the
tractor engine, remove the ignition key and engage the parking brake of
the tractor.
5.6. Adjustment of conveyor chain tension
The conveyor chains are adjusted by the stretcher screws (see fig. 4 item 1) located on the
front panel of the spreader. The tension of the chains is verified by lifting the chain at the middle
of the body floor length. The distance of the chain from the floor should be
1–6 cm
when lifted.
If the chain is stretched beyond the maximum adjustment value, replace the chain.