23
English
Removing the nails:
Pull the feeder knob backward.
Return the feeder knob forward quietly while pushing
the nail feeder (A).
Pull out nails from the back of the magazine.
Nail feeder (A)
Feeder knob
Nails
NAILER OPERATION
Read section titled “SAFETY” (pages 3–11).
DANGER
●
Operators and others in
work area MUST wear safety
glasses with side shields
which conforms to ANSI Z87.1
speci
fi
cations.
WARNING
●
NEVER point tool at yourself
or others in work area.
●
Keep
fi
ngers AWAY from
trigger when not driving nails
to avoid accidental
fi
ring.
●
Do not use the electrical cord if damaged.
Have it repaired immediately.
●
Please read and understand “METHODS OF
OPERATION” found below.
●
Never place your face, hands or feet near
fi
ring head when using.
●
Do not drive nails on top of other nails or
with Nailer at too steep of an angle; nails can
ricochet and hurt someone.
●
Do not drive nails into thin boards or near
corners and edges of workpiece. Nails can be
driven through or away from workpiece and
hit someone.
●
Be sure to position and insert the probe
through the hole in the metal connectors.
●
Do not drive nails at tilted, since the nails can
ricochet and hurt yourself or someone else.
●
Never drive nails from both sides of a wall
at the same time. Nails can be driven into
and through the wall and hit a person on the
opposite side.
●
Never use Nailer which is defective or
operating abnormally.
●
Do not use Nailer as hammer.
●
Remove all remaining fasteners and battery
from nailer when:
1)
doing maintenance and inspection;
2)
checking proper operation of push lever
and trigger;
3)
cleaning a jam;
4)
it is not in use;
5)
leaving work area;
6)
moving it to another location; and
7)
handing it to another person.
●
Remove battery from Nailer when:
1)
loading nails;
2)
turning the adjuster.
Explanation of nailing operations
○
FULL SEQUENTIAL ACTUATION MECHANISM:
First, press the push lever against the wood; next,
pull the trigger to drive the nail.
Follow the same sequence to continue driving nails.
After nailing once, nailing will not be possible again
until remove
fi
nger from the trigger and lift the tool o
ff
the wood surface completely.
The machine employs a preventive mechanism for
unloaded operation.
The machine enters a state where the push lever cannot
be pushed up. This takes place when the magazine is not
loaded with nails or when the remaining number of nails
becomes less than 5.
CAUTION
●
Use caution not to throw the push lever tip onto
wood when the push lever cannot be pushed up.
000Book̲NR3665DA̲metabo.indb 23
000Book̲NR3665DA̲metabo.indb 23
2021/02/22 12:20:26
2021/02/22 12:20:26
