GT-526S Manual Rev F
Page 11
4.3.7. Sample Timing
The following figures depict the sample timing sequence for both single and multiple
samples. Figure 9 shows the timing for single samples. Figure 10 shows the timing for
multiple samples.
Figure 9
– Single Sample
Figure 10
– Multiple Samples
5.
Menu Selections
The Menu is accessible by pressing the Menu key on the Operate Screen. The table
below shows the menu items. P
ress ▲ or ▼ to navigate to a menu item then press
Enter to display a screen where you can view or change item setting(s).
Menu Item
Description
Press Enter to
navigate to…
SAMPLE SETUP
View / change location number, samples,
sample time and hold time.
Sample Setup Screen
SETTINGS
View / change volume (count units), ºC / ºF,
baud rate and serial output mode.
Settings Screen
RECALL DATA
Recall sample history based on time
Recall Data Screen
PRINT DATA
Print stored data based on a time range.
Print Data Screen
MEMORY
View memory usage and clear memory.
Memory Screen
COUNT ALARMS
Set count alarm limits for 2 particle sizes
Count Alarm Screen
SERIAL
Set baud rate and serial output mode
Serial Screen
SET FLOW
Adjust the sample flow rate
Flow Screen
SET SIZES
Set particle sizes
Set Sizes Screen
SET CLOCK
Set the date and time.
Set Clock Screen
SET CONTRAST
Adjust the display contrast.
Set Contrast Screen
ABOUT
Display firmware version and serial number.
About Screen
5.1.
Edit Menu Items
To change settings, press Menu to display the main menu,
press ▲ or ▼ to navigate to
the desired item and press Enter to display the item view/edit screen.
Start
Time
Sample Time
Stop
Time
Start
Time
Sample Time
Hold Time
Sample Time
Stop
Time
