Messoa NDZ760, Руководство пользователя, Страница: 34 / 80

Network Camera User’s Guide
34/80
In case, user wants to configure wireless settings manually, please follow the steps as below:
MAC address:
Displays the Ethernet MAC address of the WLAN card. Note that user cannot change it.
Site survey:
Click the “Refresh” button. It will refresh information window which list is the result of a
network scan. Access points with a disabled SSID Broadcast will not appear unless the
camera is associated with it. The following information is provided:
Interface Select:
“Wired (Ethernet) only” or “Auto – wired if cable connected, otherwise wireless”:
Choose wired or wireless mode. However, note that wired is priority.
Type:
To select one of WLAN modes from Infrastructure or Ad-Hoc mode.
Security mode:
Shows which type of security the network uses. The device supports three security methods:
None, WEP, WPA_PSK/WPA2_PSK
SSID:
This is the name of the wireless network the device is configured for. The field accepts up to
32 alphanumeric characters. The name must be exactly the same as that used in the wireless
access point, or the connection will not be established.
Leaving this field blank means the device will attempt to access the nearest open network.
Channel:
Chooses the wireless channel in use currently.
WEP settings:

Authentication:
Select Open or Shared Key System Authentication, depending on the method used by
your access point. Not all access points have this option, in which case they probably
use Open System, which is sometimes known as SSID Authentication.

WEP Mode:
The key types available depend on the access point being used. The following options
are available:

ASCII - In this method the string must be exactly 5 characters for 64-bit WEP and 13
characters for 128-bit WEP.

HEX - In this method the string must be exactly 10 hexadecimal (0-9, A-F) characters
for 64-bit WEP and 26 hexadecimal characters for 128-bit WEP.

Web Key 1~4:

Key value of WEP.
WPA settings:

WPA Key:
Key value of WPA. The device uses a pre-shared key (PSK) for key management. The
pre-shared key can be entered either as Manual hex, as 64 hexadecimal characters, or
as a Passphrase, using 8 to 63 ASCII characters.
Obtain IP address automatically (DHCP):
Enable this checked box when a DHCP server is installed on the network to issue IP address
assignment. With this setting, the IP address is assigned automatically.
IP address, Subnet mask, and Gateway:
If you do not select Obtain an IP address automatically , then you need to enter these
network parameters manually.