16
- Shutter up / down
Open shutter (up) by pressing top push-
button for longer (> 0.8 s) (top/left in the
case of external push-buttons).
Close shutter (down) by pressing bottom
push-button for longer (> 0.8 s) bottom/
right in the case of external push-buttons.
Note
A drive that has been set in motion
stops itself after a period of operation
of 2 min. If the key is pressed again
(> 0,8 s) before this period elapses, the
period of operation of 2 min is restar-
ted.
If the direction of movement is chan-
ged, the drive first stops and then starts
moving in the selected direction after a
switchover time of 0.5 s.
The shutters can be stopped by briefly
(< 0,8 s) pressing a push-button.
Anleitung_777204.book Seite 16 Montag, 14. Oktober 2002 7:37 19
17
- Safety (e.g. wind alarm)
If the Easy shutter actuator REG-K/
4x(1x230)/6 receives the ”alarm” signal
from the relevant sensor (e.g. wind sensor),
the drive moves into the safe position.
Note
See parameters
Opening / closing of the shutter via push-
buttons is locked until the sensor unlocks
the shutter function again.
Electrical connection
Caution
The switch outputs have a bistable relay.
Strong vibrations during transportation can
cause the switching contacts of the out-
puts to change to the switched-on state.
When connecting to the mains, the outputs
may contain a voltage!
(Also see chapter Start-up with shutter
actuator)
Connection example 1:
Fig. C:
Installation
Anleitung_777204.book Seite 17 Montag, 14. Oktober 2002 7:37 19
18
Connection example 2:
Fig. D:
Installation proposal:
Fig. E:
➊
Connect the red bus wire to the red
terminal (+) and the black one to the
dark grey terminal (-).
➋
The screen and the stability wire as
well as the white and yellow wires of
the bus line are not required. Insulate
and put in them in the line cover
➌
.
Fig. F:
➌
Push line cover onto bus connection.
➍
Close flap.
Fig. G:
➎
Connect the 4 channel connections (A
- D) to the twin screw terminals as
shown in the connection example.
Plug the twin screw terminals into the
Easy shutter actuator REG-K/
4x(1x230)/6.
Anleitung_777204.book Seite 18 Montag, 14. Oktober 2002 7:37 19
