merten CONNECT 5069 SERIES, Инструкция, Страница: 55 / 169

Options
53
IR AV devices
Programming in an IR AV device on the remote
control
You can set up the remote control for operation of up to five devices:
1
Switch on the device which you want to set up for the remote
control.
– If the device is a DVD player/recorder or video recorder, insert
a disc or tape and start playback.
2
Switch the remote control to setup mode:
– Press [SELECT] for three seconds.
– The display shows ,
and “
CONFIG DEVICE ?
”.
– The background lighting is switched on.
– The keys that you can use are flashing.
3
Confirm with [OK] .
The remote control is now ready to be set up for operation of your
device.
4
Select device with [
▼
] .
5
Confirm with [OK] .
– The display shows and a brand name.
– The keys that you can use are flashing.
6
Select the brand of the device with [
▼
] and [
▲
] .
– If the brand of your device is not in the list, you can select any
other brand.
7
Confirm with [OK] .
8
Hold down [ ] until the device responds.
– The display shows .
9
Aim the remote control at the device.
– The remote control starts sending all known “Off” codes one
after the other. Each time the remote control sends a code,
the display shows the following: “
TEST 01, 02, 03
” etc.
0
When the device responds, release [ ] immediately.
– The remote control has now found a code which works with
your device. „
SETUP OK
” appears on the display.
– If the device does not respond and “
LIST END
” appears, no
code was found for the device.
Options
Device Shown on display
TV
TV
AMP (hifi receiver/amplifier)
AMP
SAT (satellite TV receiver)
SAT
DMR (Digital Media Receiver)
DMR
DVD/VCR (DVD player/video recorder)
DVD/VCR