LATCH Installation—Tether Required, Continued
6. While placing your knee
into the restraint, remove
slack from the webbing by
pulling the two free ends.
(Figure E).
7. Verify that there is no
slack in the webbing. If
there is any slack, remove
it as described in Step 6
and shown in Figure E.
8. Check the stability of the
restraint according to the
guidelines at the bottom
of page 29.
9. Use of the tether(s) is
required. See pages 42
and 43 for the tether
installation procedure.
Note: Remove the
restraint as follows:
1. Press down firmly on one
of the adjuster buttons to
loosen the webbing
(Figure F).
2. If necessary, repeat Step 1
with the other adjuster.
3. Unhook each of the lower
hooks (Figure G).
4. Store the LATCH
assembly as shown in
Figure A, Page 38.
G
Page 41
F
E
