MEROTEC Yard force YF48vRX-RER38, Руководство пользователя

Страница: 41 / 45

41
TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YARD FORCE CUSTOMER SERVICE AT
866-902-9690
Fault/Malfunction Cause(s) Solution(s)
Mower not starting.
1. Battery charge is low.
2. Charger is connected to mower.
3. Start key not installed or is in
OFF position.
4. Poor battery cable connections.
1. Charge the battery.
2. Disconnect charger from mower.
3. Install start key and turn to ON
position.
4. Check/clean all battery
connections.
Mower won’t move.
1. Start key not installed or is in
OFF position.
2. Parking pedal is set.
3. Direction control switch is in
neutral (N).
4. Brake is depressed and/or
accelerator pedal is not pressed.
5. Charger is connected to mower.
1. Install start key and turn to ON
position.
2. Release parking pedal.
3. Place direction control switch
in desired direction (forward or
reverse).
4. Release the brake pedal and
press the accelerator.
5. Disconnect charger from mower.
Mower cutting grass unevenly.
1. Wet grass clippings sticking to
the underside of the deck.
2. Grass is too high.
3. Worn, bent, loose, or dull blade.
4. Mowing speed is too fast.
1. Wait until the grass dries before
mowing.
2. Mow once at a high cutting
height, then mow again at the
desired height.
3. Replace blade.
4. Mow at a slower speed.
Mower vibrating at higher
speed.
1. Blade is unbalanced, loose, or
excessively or unevenly worn.
2. Bent motor shaft.
1. Replace the blade.
2. Stop the motor and remove
start key. Inspect for damage.
Have repaired by an authorized
service center before restarting.
Poor grass discharge.
1. Side discharge chute or opening
is plugged.
2. Grass is wet.
3. Mowing speed is too fast. Grass
is too high.
1. Clean side discharge chute and/
or opening.
2. Allow grass to dry before
mowing. Mow at a slower
speed.
3. Mow once at a high cutting
height, then mow again at the
desired height.
Motor stops while cutting.
1. Cutting height set too low.
2. Battery charge is low. 1. Raise the cutting height.
2. Charge the battery.
Blades do not rotate.
1. Battery charge is low.
2. Blade engage knob is down.
3. Operator is not fully seated.
4. Build-up of debris under mower. 1. Charge the battery.
2. Raise blade engage knob.
3. Sit down fully on the seat.
4. Clean underside of mower
housing.
Blades do not rotate while
moving in reverse.
1. Reverse mode option is off.
2. Blade engage knob is down. 1. Press reverse mode button to
activate.
2. Raise blade engage knob.
Mower won’t reach full speed. 1. Battery charge is low. 1. Charge the battery.