38
NOTE:
To gain enough leverage to reconnect, it is often easier to connect from the battery compartment
area rather than the area under the seat.
• Once the batteries are reconnected to the mower, push the battery tray fully back inside the mower.
• Reinstall flange bolts and flange nuts to secure outside edge of battery tray. Tighten securely.
• Reinstall hex head bolt to secure battery tray in place. Tighten securely.
• Replace battery compartment cover and reinstall hardware to secure.
NOTE:
Make sure the tabs on the battery compartment cover are seated in the slots on the mower top and
side panels before tightening screws.
• Reinstall wiring cover and push down until it latches securely in place, then lower the mower seat.
NOTE:
Always ensure the safety interlock cable connection is still fully seated when replacing the wiring
cover.
NOTE:
Always abide by the safety warnings provided with the battery. Dispose of old battery according to
local and state regulations.
CHANGING/ADDING TRANSAXLE OIL (See Fig. 34)
NOTE:
To access the transaxle, you must remove the battery tray from the mower. Refer to the section
Replacing the Batteries for instructions on how to fully extend the battery tray, then continue to extend the
tray all the way out of the mower so that you can access the transaxle. Once the battery tray is removed,
you may proceed with the steps below.
• Park the mower on a flat, level surface. Allow the mower to cool before draining transaxle oil.
• Place a container underneath the transaxle oil drain plug.
• Remove the fill hole plug from the top of the transaxle.
• Remove the drain plug and drain the old oil.
• Clean the bottom drain plug, then reinstall plug and tighten securely.
• Pour 200cc new, clean GL4 80W/90 gear oil into the fill hole.
• Reinstall fill hole plug and tighten securely. Do not over- tighten.
• Reinstall the battery tray as described in Replacing the Batteries.
NOTE:
Consult hazardous waste management guidelines in your area for the proper way to dispose of used
gear oil.
STORING THE MOWER
The following steps should be taken before storing the mower for the season.
• Remove any build-up of grass and leaves on or around the motor cover. Wipe the mower clean with a
dry cloth. Do not spray with a garden hose to clean.
• Plug the mower up to charge for the entire time of storage.
NOTE:
If it is not possible to leave the mower charger connected during storage, charge the batteries at
least once a month during storage.
• Store mower in a clean, dry place that is inaccessible to children. Do not store near any appliance that
operates with flame such as a gas water heater, clothes dryer, or furnace.
NOTE:
Do not leave the key in the mower during storage.
• If the mower must be stored outside, make sure it is covered completely to protect it from the elements.
• Keep away from corrosive agents such as garden chemicals and deicing salts.
MAINTENANCE AND STOARGE
Fig. 34
Fill Hole Plug
Transaxle
Oil Drain Plug
Содержание Yard force YF48vRX-RER38
Страница 44: ...44 1 5 S l o p e 1 5 L i n e 1 5 S l o p e ...
