MEROTEC Yard force YF48vRX-RER38, Руководство пользователя

Страница: 31 / 45

31
ADJUSTING CUTTING DECK WHEELS (See Fig. 23)
The cutting deck wheels should be positioned approximately 1/2 in. off the ground when the mower is at the
desired cutting height. This will minimize the chance of scalping the lawn in most situations. When shipped,
the wheels are positioned in Position A.
To adjust the cutting deck wheels:
• Park the mower on a level surface and set the parking brake.
• Stop the motor and remove the start key. Allow blades to come to a complete stop.
• Raise the cutting deck to the desired height setting.
• Remove nut and bolt holding cutting deck wheel in place.
• Move wheel to desired position. Available hole positions are 1.5 in. (A), 1.75 in. (B), 2 in. (C) and 2.25 in.
(D).
• Replace bolt and nut; tighten securely. Torque nut to 4-6 ft. lbs.
• Repeat with remaining cutting deck wheel, making sure both wheels are installed in the same position.
REMOVING THE CUTTING DECK (See Fig. 24.)
If desired, the cutting deck can be removed from the mower to make accessing the blades easier when
changing.
• Make sure direction control switch is in neutral (N) position and blade engage knob is down.
• Stop the motor, remove the start key, and set the parking brake.
• Disconnect the cables that connect the cutting deck to the mower.
• Lower the cutting deck to its lowest position.
• Remove the 4 hitch pins and washers that secure the cutting deck in place.
• Slide the deck out from under the mower.
• Reverse the process to reattach the cutting deck to the mower.
MAINTENANCE AND STOARGE
Fig. 23
Nut
Bolt
A
C
D
B
Wheel
Cutting Deck
Hitch Pin
Washer
Cable
Fig. 24