Merlin POLARIS 400CP, Инструкция по эксплуатации

Страница: 9 / 60

7
Control Test
•
Be certain that the throttle stick is in the “off” position.
•
Switch on the transmitter, fully extend the aerial and check to make sure the green LED is lit indicating the
transmitter has power. If the red LED is lit then transmitter batteries are low on power and must be replaced
before flying.
•
Plug in the helicopter battery and wait 5 seconds for the receiver power light to stop flashing to confirm the
unit has calibrated.
•
Place your model on the ground and walk away whilst operating the swash plate controls.
•
Check that the servos operate without interference up to a distance of 30 metres.
•
Gently move the throttle stick forwards to check the main blades rotate.
Checklist
Each time before you start flying your Merlin Flight Product, please carry out the following checks and tests.
•
Make sure the Swash plate has free movement
•
All screws, bolts, etc. are tight
•
Radio equipment is securely fastened inside fuselage
•
Batteries are fully charged.
•
No wires interfere with servo motors
•
Antenna is properly strung
•
Blades are securely fastened