external neutral
sensor
remove front accessory cover.
terminals S1 and S2 of
neutral sensor to circuit breaker
terminals T1 and T2 respectively.
Use 14 AWG wires routed
together for
50ft
maximum run,
apart from the power conductors.
m
replace front accessory cover
fault and alarm
indicators
(option F)
1·
remove front accessory cover
2-
refer to the main technical
manual to connect terminals F11
and F12
3-
terminals pressure type secured
[I]
remove terminal using a
scewdriver and knock-out one of
the precut grooves
m
replace terminal. .
Caution : open circuit breaker
and disconnect control power
before removing the accessory
cover
by a screw on the breaker. Each
4- remove front accessory cover
terminal may
be
connected by one
stranded copper wire 18 to 14 AWG.
Cable strip length
:
3/8"
approx.
In the factory these terminals are
facing towards the top of circuit
breaker. For his convenience the
end user may direct them to the
N
__
,rUl1
) ) ) �
external
L-f11-J
neutral
sensor
breaker
side of the brea
�
er. This can be
done easly on s1te
:
14
www
. ElectricalPartManuals
. com