MERIT INDUSTRIES Megatouch XL, Техническое руководство по обслуживанию

Страница: 22 / 65

Removal and Installation of Microtouch Touchscreen Glass Overlay
Removing the Touchscreen Overlay
1. Remove the monitor assembly as explained in the Cabinet Information Section - Removal of
Major Parts.
2. Remove the first layer of black tape around the edge of the glass.
3. Spray alcohol over the second layer of tape to loosen the adhesive.
4. Carefully cut the second layer of tape by running a razor blade along the gap between the
monitor and the touchscreen overlay.
5. While continuing to spray the tape with alcohol, remove the remaining tape by CAREFULLY
running the blade under the tape and gently peeling it up from the glass. Do this until all tape and
adhesive have been removed from the glass.
Installing the Touchscreen Overlay*
Countertop model:
1. Place the touchscreen glass over the monitor glass, so that the touchscreen cable is to your right
(when facing the monitor).
2. Apply one piece of the black, double-sided tape to each edge of the glass, to hold it to the
monitor.
3. Apply the black cloth tape around the entire perimeter of the monitor, securing the touchscreen
glass to the monitor and covering the double-sided tape.
4. Place the monitor assembly back into the cabinet and secure it in position.
5. Run the cable through a hole on the side of the monitor chassis and into the CPU section.
6. Attach the touchscreen connector to the back of the SMT-3 controller.
Upright and Cabaret models:
1. Place the touchscreen glass over the monitor glass, so that the touchscreen cable is to your right
(when facing the monitor). Upright models only*: Install the supplied foam tape around the edges
of the monitor, where it meets the bezel.
2. Place the monitor assembly back into the cabinet and secure it in position.
3. Run the cable through the rear of the cabinet and into CPU section.
4. Attach the touchscreen connector to the back of the SMT-3 controller.
* When installing a new touchscreen overlay on a 19” upright model, make certain that the metal of the
monitor bezel door does not contact the glass. The bezel should fit snugly against the foam tape,
WITHOUT CRUSHING THE TAPE. You must also recalibrate the touchscreen after closing the monitor
door.