COPYRIGHT © 2003 MERIT INDUSTRIES, INC.
FIGURE 17 - PHONE SETTINGS SCREEN
FIGURE 16 - INSTALL SCREEN
PM0378-07 MEGATOUCH COMBO JUKEBOX™ OWNER’S MANUAL 15
33. Touch the ‘TouchTunes’ button on the
Main Menu, then the ‘TouchTunes Setup’
button. The INSTALL screen will ap-
pear. See Figure 16.
34. Take note of the information on the
screen and press NEXT. The PHONE
SETTINGS Screen will appear. See Fig-
ure 17.
35. Set the time during which the jukebox
can use the phone line to call out to the
TouchTunes® server. Time is speci-
fied using a 24-hour clock (i.e. 00:00
equals midnight).
NOTE: The more time you make avail-
able, the more songs the jukebox will
be able to download at one time (a
single songs takes about 20 to 25 min-
utes to download). The busiest time for
the server is between 4 AM and 8 AM
Eastern time. If you can set your unit to
call outside this time, you may get bet-
ter throughput. It is suggested you set
CALL FROM to one half hour after the
location is locked up for the night (i.e.,
the time the last person leaves and locks
the front door) and set CALL TO to one
half hour before the first person enters
the location. Once a song file begins
downloading, it will continue through
to completion, which may exceed the
end time specified. The half-hour
buffer should prevent phone conflicts.
36. Enable the WAIT FOR DIALTONE op-
tion to turn on dial tone detection. If this
feature is left off, the jukebox will auto-
matically start dialing after a two-sec-
ond delay. For voice mail compliance, it
is recommended you leave this feature
off in order to solve dialing problems
on the phone line. When voice mail is
installed, the jukebox modem may not
be able to recognize the dial tone fol-
lowing the voice mail signal because in
many cases, the dial tone is intermit-
tent due to message beeps.
If it is necessary at your location to dial
the number 9 to gain access to an out-
side line, turn on DIAL 9 FOR EXTER-
NAL LINE. If a different outgoing pre-
fix needs to be dialed, use the EDIT
button in the CUSTOM DIAL PREFIX
box to bring up a numeric keypad for
entering the prefix.
If the location has call waiting, you
should enter the prefix to disable it. In
most cases this is *70. You may need
to add a pause to the end of this se-
quence, as sometimes there is a delay
before the dial tone returns. Use the #
key to enter a pause. For example, the
sequence *70## disables call waiting
and then pauses twice before continu-
ing to dial.
Select the type of phone line that is
installed at the location by setting TONE
DIALING to ON or OFF.