Meridian G92, Руководство по установке

Страница: 43 / 64

C o n f i g u r i n g
t h e D V D p l a y e r
Speakers
To configure speakers
If you are using the G92 in a surround application, directly
connected to up to six DSP loudspeakers, or power amplifiers
and analogue loudspeakers, the
Speakers menu allows you to
configure the speaker layout and enter calibration settings.
• Highlight Speakers… in the Audio setup menu, and press
Enter .
The
Speakers
menu will be displayed:
The options are summarised in the following table:
To calibrate the speaker layout
• Highlight Calibration… in the Speakers menu, and press
Enter .
The Calibration menu will be displayed:
• Highlight Distance units and press Enter to change the
distance units between cm and inches.
Then for each speaker adjust the Gain and Distance as follows:
• Press V to highlight the Gain figure and press Enter to edit it.
You will hear a noise test signal from the corresponding channel.
Option Values Description
Left/Right L DSP, S DSP, L An, S An Whether the main left and right loudspeakers should handle the bass (Large),
and their type.
Centre Off, L DSP, S DSP, L An, S An Whether there is a centre loudspeaker, and its bass handling and type.
Subwoofer Off, Dig, An Whether there is a subwoofer, and its type.
Surround Off, L DSP, S DSP, L An, S An Whether there are rear surround speakers, and their bass handling and type.
Calibration… See above.