Meridian DSP5200, Руководство пользователя

Страница: 28 / 73

DSP5500, DSP5500HC,
AND DSP5500C
21
• Screw each foot into the threads on the bottom of the loudspeaker. Do
not fully tighten the lock nut at this stage.
• On solid fl oors fi t the protectors over the spikes.
• When all four feet have been fi tted, carefully set the DSP loudspeakers
upright in their playing positions and remove the rest of the packaging.
• Adjust the feet until the speakers are stable, and then tighten the lock
nuts.
To fi t the rubber bumpons (DSP5000HC only)
• Attach four bumpons to the underside of each speaker, using the self-
adhesive pads.
Tightening the drive units
The DSP loudspeakers typically take about two weeks of normal use for the
drive units to settle. It is therefore recommended that you tighten the
mounting bolts on each drive unit every few days during this period.
Tighten the bolts in symmetrically opposite pairs using the 3mm hex
wrench supplied.
You should then check and if necessary retighten the drive units every few
years.
Removing the grilles
The DSP5500 grille frame has been designed to be as acoustically
transparent as possible, and is quite fragile. When removing the grille, ease
it carefully off by hand from the bottom and sides, avoiding excessive
bending of the frame.