Mercury TowSport Inboards, Руководство пользователя

Страница: 88 / 108

SPECIFICATIONS AND MAINTENANCE
Page 82 90-864197020 MARCH 2002
2. If flushing the engine with the boat out of the water, remove the propeller. Refer to
boat manufacturers’ instructions.
a. Models with Walter V-Drive Transmissions: Disconnect water inlet hose from
transmission fitting. Using appropriate connector, connect the flushing hose.
Proceed to Step 3.
75191
b. All other models: Using appropriate connector, connect the flushing hose from the
water to the water inlet hose (upper hose) of the seawater pickup pump. Proceed
to Step 3.
77908
3. Open the water source.
4. Place remote control in NEUTRAL, idle speed position, and start engine. Operate
engine at idle speed, in NEUTRAL, for about 10 minutes or until discharge water is clear.
5. Stop the engine.
6. Remove the flushing connector from the water inlet.
7. Reconnect the water inlet hose.
8. Tighten hose clamp securely.
9. Attach to the next engine, if equipped, and repeat procedure.
10. Turn off the water source.
11. Open the water inlet or remove the plug from the water inlet fitting and reinstall the water
inlet hose.
12. Replace the propeller if removed. Refer to the boat manufacturers’ instructions.