Mercury TDI 4.2L, Руководство пользователя

Страница: 75 / 89

Section 5 - Storage
90-8M0114081
eng
DECEMBER 2015 Page 69
NOTICE
Water trapped in the seawater section of the cooling system can cause corrosion or freeze damage. Drain the seawater
section of the cooling system immediately after operation or before any length of storage in freezing temperatures. If the boat
is in the water, keep the seacock closed until restarting the engine to prevent water from flowing back into the cooling system.
If the boat is not fitted with a seacock, leave the water inlet hose disconnected and plugged.
IMPORTANT: Mercury Diesel recommends that propylene glycol antifreeze be used in the seawater section of the cooling
system for cold weather (freezing temperature), seasonal storage, or extended storage. Make sure that the propylene
glycol antifreeze contains a rust inhibitor and is recommended for use in marine engines. Be certain to follow the propylene
glycol manufacturer's recommendations.
3. Fill a container with approximately 5.6 Liter (6.0 US qt) of propylene glycol antifreeze and tap water mixed to
manufacturer's recommendation to provide –73.3 °C (–100 °F) protection to the engine.
4. Disconnect the seawater inlet hose from the seawater pump. Using an adapter, if required, temporarily connect an
appropriate length piece of hose to the seawater pump and place the other end of the hose into the container of propylene
glycol antifreeze and tap water.
a - Seawater pump
b - Container of propylene glycol
antifreeze and tap water
NOTE: Discharge of propylene glycol antifreeze into the environment may be restricted by law. Dispose of propylene glycol
antifreeze in accordance with federal, state, and local laws and guidelines.
5. Start the engine and operate at idle speed until the antifreeze mixture has been pumped into the engine seawater cooling
system.
6. Stop the engine.
7. Remove the temporary hose from the seawater pump.
8. Clean the outside of the engine and repaint any areas required with primer and spray paint. After the paint has dried, coat
the engine with the specified corrosion inhibiting oil or equivalent.
Description Where Used Part Number
Corrosion Guard
Outside of engine, transom assembly, and
sterndrive
92‑802878‑55
Light gray primer paint
Outside of engine, transom assembly, and
sterndrive
92‑802878‑52
Phantom black paint Transom assembly and sterndrive 92‑802878‑1
Diesel white paint Outside of engine 92‑8M0071082
9. Your Mercury Diesel–authorized repair facility should now perform all checks, inspections, lubrications, and fluid changes
outlined in
Maintenance Schedules
.
NOTICE
The universal joint bellows may develop a set when stored in a raised or up position, causing the bellows to fail when
returned to service and allowing water to enter the boat. Store the sterndrive in the full down position.
10. Place the sterndrive in the full down (in) position.
11. Follow the battery manufacturer's instructions for storage and store the battery.
Extended Storage Instructions
IMPORTANT: Mercury Diesel strongly recommends that this service be performed by an Mercury Diesel–authorized repair
facility.
1. Read all precautions and perform all procedures found in
Preparing Your Power Package for Seasonal or Extended
Storage
.
2. Read all precautions and perform all procedures found in
Flushing and Draining the Seawater System
.
50893
a
b