Several air bag system components get hot after inflation. Do not
touch them after inflation.
If the air bag has deployed,
the air bag will not function
again and must be replaced immediately.
If the air bag is not
replaced, the unrepaired area will increase the risk of injury in a
collision.
The SRS consists of:
•
driver and passenger airbag modules (which include the inflators and
airbags).
•
Safety Canopy
娂
system (if equipped). Refer to
Safety Canopy
娂
system
later in this chapter.
•
one or more impact and safing sensors.
•
a readiness light and tone.
•
diagnostic module.
•
and the electrical wiring which connects the components.
The diagnostic module monitors its own internal circuits and the
supplemental airbag electrical system wiring (including the impact
sensors), the system wiring, the airbag system readiness light, the airbag
back up power and the airbag ignitors.
Determining if the system is operational
The SRS uses a readiness light in the instrument cluster or a tone to
indicate the condition of the system. Refer to
Airbag readiness
section
in the
Instrument Cluster
chapter. Routine maintenance of the airbag is
not required.
A difficulty with the system is indicated by one or more of the following:
•
The readiness light will either
flash or stay lit.
•
The readiness light will not
illuminate immediately after
ignition is turned on.
•
A series of five beeps will be heard. The tone pattern will repeat
periodically until the problem and/or light are repaired.
If any of these things happen, even intermittently, have the SRS serviced
at your dealership or by a qualified technician immediately. Unless
serviced, the system may not function properly in the event of a
collision.
2005 Mountaineer
(mnt)
Owners Guide (post-2002-fmt)
USA
(fus)
Seating and Safety Restraints
134
