Mercury 1000 Dual Fuel, Руководство пользователя и инструкции по установке

Страница: 31 / 36

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
27
Burner head
Burner base
Brass venturi
Fig.8-1
Natural Gas Propane Gas
Centre burner 165 107
Large burners 120 82
Right front burner 95 64
Table 8-1
Fig.8-2
Hotplate screw
Fig.8-3
Fig.8-4
Check the ‘Technical Data’ section at the back of the book
that the hob is convertible to the gas you want to use.
A suitably competent person must perform the conversion.
After conversion the installation must comply with the
relevant regulations and also the local electricity supply
company requirements. Read the instructions before
converting this appliance.
nn
Failure to convert the appliance correctly could
invalidate any warranty or liability claims and lead
to prosecution.
n n
When servicing or replacing gas-carrying
components disconnect from the gas supply before
starting operation. Check the appliance is gas sound
after completion.
n n
DO NOT use reconditioned or unauthorised gas
controls.
n n
Disconnect from the electricity supply before
servicing. Before electrical reconnection, check that
the appliance is electrically safe.
Injectors
Remove the pan supports and burner heads. For each burner,
remove the large brass venturi on the top of the burner base
(Fig.8-1) . Remove the burner base, making sure to disconnect
the ignition lead from the spark electrode.
Replacing the Jets
Either:
Use a long box spanner to access and remove the old
jets. Fit the new jets: see
Table 8-1
for the correct type.
Or:
Remove the control panel and hotplate (see below) .
Remove the jets.
Removing the Control Panel and Hotplate
Note: To allow the control panel removal make sure the side
panels are removed.
Remove the control knobs. Undo the screws holding the
control panel in position
(Fig.8-2)
. Pull the control panel
forwards, taking care not to damage it (by protecting it with
cloth, for example) rest it on the open grill door and oven
door. Carefully remove the 4 neon connections. Now remove
the control panel.
Remove the 2 screws holding the hotplate in position
(Fig.8-3) . Slide the hotplate forwards and remove.
Remove the old jets. Save the jets removed from the
appliance for possible future use. Fit the new jets: see
Table 8-1 for the correct type.
Refit the hotplate, making sure to feed the ignition leads back
through the hotplate.
Note: When refitting the hotplate, take care not to damage or
displace the flame safety probes
(Fig.8-4)
.
8. Conversion to LP Gas