mcr FIND WING
fire protection cut-off damper
MERCOR SA –
The company reserves the right to modify and change the document. Version: mcr FID WING 21.08.02.1
15/15
9. If the device can not be repaired at the place of its installation, "MERCOR" SA reserves the necessity
of its disassembly, possible delivery to the address indicated by "MERCOR" SA and re-assembly.
The cost of this operation lies with the buyer / holder of the guarantee.
10. The warranty does not cover:
Any damage or failure of the equipment caused by improper operation, tampering, failure to
conduct periodic technical inspection and/or maintenance established in the Operating and
Maintenance Manual, section “SERVICING AND MAINTENANCE”.
Any damage beyond reasonable control of “MERCOR” SA, and specifically: caused
by force majeure, such as torrential rainfall, flooding, hurricanes, inundation, lightning
strike, power grid overvoltage, explosion, hail, collision with aircraft, fire, avalanche,
landslide and indirect damage due to those causes. Torrential rainfall is understood as
any rainfall with the effectiveness factor of 4 or higher in accordance with the definition
of the Polish Institute of Meteorology and Water Management - National Research
Institute (IMGW-PIB). If the effectiveness factor value specified in the preceding
sentence cannot be reasonably established, the actual condition and extent of damage
shall be considered at the site of their origin as the action of torrential rain. Hurricane
is understood as any wind with a minimum speed of 17.5 m/s (and damage shall be
recognised as caused by hurricanes if the effects of such weather phenomenon has
been found in the direct vicinity of the damaged property).
Damage due to failure to immediately report any defect found.
Deterioration in the quality of coatings due to natural weathering/ageing.
Defects caused by abrasive or aggressive cleaning agents.
Damage caused by aggressive external influence, specifically chemical or biological
in nature, or when the origin of which is related to the production processing or activity
carried out within the facility protected by the equipment or in its direct vicinity.
Wearing parts and consumables (e.g. gaskets/seals), unless they have defects of
workmanship and/or material.
Damage caused by improper transport, handling, unloading and/or storage of the
equipment.
Damage caused by installation of the equipment in violation of this Operating and
Maintenance Manual and/or good construction practice.
The equipment and/or parts thereof with removed or damaged nameplate (rating plate)
and/or warranty seals.
11. The buyer/warranty rights holder is required to operate the equipment properly and carry out
technical inspection and maintenance in accordance with the section “MAINTENANCE AND
SERVICING” in the following Operating and Maintenance Manual.
12. This warranty shall be made immediately void and null if:
The buyer/warranty rights holder modifies the product design without prior authorisation from
“MERCOR” SA.
Periodic technical inspection and/or maintenance is not carried out per schedule and/or is
carried out by unauthorised personnel or service providers not authorised to do so by
“MERCOR” SA and/or the equipment has not been properly operated.
Unauthorised personnel attempts any intervention in the product outside of the normal
operation and maintenance of this equipment.
The device's thermal trigger was affected by a temperature greater than Tmax (page 3 of the
Operation Manual).
13. Any circumstances listed in Item 10 will relieve “MERCOR” SA from the obligation of surety.
The relevant provisions of the Polish Civil Code shall apply to all matters not regulated in these Warranty Terms & Conditions.
