Merco MHC22SNL1T, Оригинальное руководство пользователя

Страница: 5 / 30

Part Number: MER_IOM_8197455 1-1
Model Numbers
Models Description
MHC22SNT1T 2x2 - Front Display
MHC22SNL1T 2x2 - Front Display Landscape
MHC24SNT2T 2x4 - Front and Rear Display
MHC52SNT1T 5x2 - Front Display
MHC54SNT1T 5x4 - Front Displays
Serial Number Information
MHC visual holding cabinet serial and model numbers are
located on the data plate. The data plate is located on the
top right rear of the unit.
Always have the serial number of your unit available
when calling for parts or service.
Service Personnel
All service on Merco equipment must be performed by
qualified, certified, licensed, and/or authorized or service
personnel.
Qualified service personnel are those who are familiar
with Merco equipment and who have been authorized by
Merco to perform service on the equipment. All authorized
service personnel are required to be equipped with a
complete set of service and parts manuals, and to stock a
minimum amount of parts for Merco equipment. A list
of Merco Factory Authorized Servicers (FAS’s) is located
on the Merco website at http://www.mercoproducts.
com/Service#Service . Failure to use qualified service
personnel will void the Merco warranty on your equipment.
Warranty Information
Visit http://www.mercoproducts.com/Service#Warranty to:
• Register your product for warranty.
• Verify warranty information.
• View and download a copy of your warranty.
Regulatory Certifications
Models are certified by:
• Underwriters Laboratories Sanitation
• Underwriters Laboratories (UL)
• Underwriters Laboratories of Canada (CUL)
FCC Information
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. Howev¬er,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This device complies with Industry Canada’s license-exempt
RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
1) l’appareil ne doit pas produire de brouillage;
2) l’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
In order to comply with FCC/ISED RF Exposure
requirements, this device must be installed to provide at
Section 1
General Information