P 7
Front roof boards
Front view
Please retain product label and instructions for future reference
23b
18
18
Pre drill
hole
70mm
screw
12
12
12
a
b
Step 11
Parts needed - No. 12 QTY 3
Align the Roof Purlin(
s
) (
No.
12
) into the cut out slots on each
gable top ensuring each Roof Purlin
interlocks the boards.
Secure the Roof Purlin at
each end by screwing through the
bars into the boards (
ensure to
pre-drill to avoid the boards
splitting
) using 4x70mm screws per
Roof Purlin.
*Please note:
The gable shown is for
illustrative purposes and may differ
in width from your choice in
product.
Nevertheless, despite any
differences
the process of fixing the
Roof Purlins
is the same.
12x70mm Screws
a
b
IMPORTANT:
Pre-drill before fixing screws.
40mm
screw
Pre drill
hole
*
Cut to fit
Step 12
Parts needed - No. 18 QTY 56
Place the first two roof
board’s (
No. 18
) onto the assembly
on each side, making sure the
boards are flush to the end of the
roof purlin. Once in position fix to
each purlin using 3x40mm screws.
Due to natural occurences of wood
shrinkage / expansion. You maybe
required to use the provided spac-
ers and place a space of 2mm to
ensure every roof board lines up
with the truss’.
*Ensure the roof boards meet at the
top of the apex and leave an over-
hang at the bottom.
Continue adding the roof boards
along the roof, fixing each one into
position using 3x40mm screws,
making sure that each board is
interlocked, flush at the bottom &
meet at the top of the apex.
The last board on each side
will overhang: Using a straight edge
and a pencil mark out a line as
a guide.
Cut along the pencil mark and
remove the excess. Place the cut
down board’s back onto the roof
and secure into place using
3x40mm screws per board.
*Please Note:
This image is for
illustrative purposes and may
differ from your choice in product.
Nevertheless the process of
cutting and fitting the last roof
board(s) is the same.
168x40mm Screws
a
b
a
b
