Mercedes-Benz SLS AMG, Руководство пользователя

Страница: 215 / 253

X
Remove the dust protection cap from filler
hose D .
X
Screw the end of filler hose D onto the tyre
valve.
X
Make sure that on/off switch ; on the tyre
inflation compressor is set to 0.
X
Insert connector ? into the 12 V cigarette
lighter socket (
Y
page 181).
X
Select key position 2 with the Start/Stop
button (
Y
page 103).
X
Press on/off switch ; on the tyre inflation
compressor to I.
The tyre inflation compressor is switched
on. The tyre is inflated.
X
When the specified tyre pressure (see
Emergency spare wheel (
Y
page 233)) has
been reached, press on/off switch ; on
the tyre inflation compressor to 0.
The tyre inflation compressor is switched
off.
!
Do not operate the tyre inflation com-
pressor for longer than ten minutes at a
time without a break. It may otherwise
overheat.
The tyre inflation compressor can be oper-
ated again once it has cooled down.
If the tyre pressure is higher than the value
specified:
X
Open pressure release screw C until the
tyre pressure is correct.
X
Remove filler hose D from the tyre valve.
X
Stow the tyre inflation compressor in a safe
and accessible place in the vehicle.
Lowering the vehicle
G
WARNING
Inflate the collapsible emergency spare wheel
before lowering the vehicle. You could other-
wise damage the wheel rim.
X
Turn the crank of the jack anti-clockwise
until the vehicle is once again standing
firmly on the ground.
X
Place the jack to one side.
X
Tighten the wheel bolts evenly in a cross-
wise pattern in the sequence indicated
( : to A ). The tightening torque must be
130 Nm.
G WARNING
Have the tightening torque checked immedi-
ately after a wheel is changed. The wheels
could work loose if they are not tightened to
a torque of 130 Nm.
X
Turn the jack back to the out-of-use posi-
tion and stow it in the boot again with the
rest of the wheel-changing tools.
For further information on stowing the col-
lapsible emergency spare wheel, see
(
Y
page 204).
i
When you are driving with the emergency
spare wheel fitted, the tyre pressure mon-
itor cannot function reliably. Only restart
the tyre pressure monitor when the defec-
tive wheel has been replaced with a new
wheel.
All fitted wheels must be equipped with
functioning sensors and the defective
wheel should no longer be in the vehicle.
212
Flat tyre
Breakdown
assistance