Mercedes-Benz SLS AMG, Руководство пользователя

Страница: 190 / 253

opener repeatedly until the door starts to
move.
The rolling code synchronisation is then
complete.
Problems when programming
If you have problems when programming the
integrated garage door opener, please note
the following:
R
check the transmitter frequency of garage
door remote control A (this can usually be
found on the rear of the remote control).
R
change the batteries in garage door remote
control A . This increases the likelihood
that garage door remote control A will
send a strong and precise signal to the
integrated remote control in the rear-view
mirror.
R
when programming, hold garage door
remote control A at different distances
and angles from the transmitter button that
you are programming. Try various angles at
a distance of between 5 and 30 cm or the
same angle but varying distances.
R
if there is another remote control for the
same garage door drive, perform the pro-
gramming steps again using this remote
control. Before performing these steps,
make sure that new batteries have been
fitted in the garage door drive remote con-
trol.
R
note that some remote controls transmit
only for a limited period (the indicator lamp
on the remote control goes out). Press the
button on the remote control again before
transmission ends.
R
align the aerial cable of the garage door
opener unit. This can improve signal recep-
tion/transmission.
Opening or closing the garage door
Once programmed, the integrated garage
door opener will assume the function of the
garage door system's remote control. Please
also read the operating instructions for the
garage door system.
X
Select key position 2 with the Start/Stop
button.
X
Press overhead control panel transmitter
button ; , = or ? that you have pro-
grammed to operate the garage door.
Garage door system with a fixed code: indi-
cator lamp : lights up green.
Garage door system with a rolling code:
indicator lamp : flashes green.
i
The transmitter will transmit a signal for
as long as the transmitter button is
pressed. The transmission is halted after a
maximum of 10 seconds, and indicator
lamp : flashes yellow. Press the transmit-
ter button again, if necessary.
Clearing the memory of the integrated
garage door opener in the rear-view mir-
ror
X
Select key position 2 with the Start/Stop
button.
X
Press transmitter buttons ; and ? .
The indicator lamp lights up yellow.
X
Press and hold transmitter buttons ;
and ? until the indicator lamp turns green.
i
Make sure that you clear the memory of
the integrated garage door opener before
selling the vehicle.
Frequencies for the garage door opener
The radio type approval number and the fre-
quency range for the garage door opener can
be found on the Internet at: http://
www.mercedes-benz.de/betriebsanleitung.
Charge maintenance socket
The battery may drain if the vehicle is left sta-
tionary for long periods. In this case,
Mercedes-Benz recommends attaching the
Features
187
Stowing
and
features
Z