Mercedes-Benz S-Class Coupe, Руководство пользователя

Страница: 394 / 413

X
Clean the wheel and wheel hub contact
surfaces.
X
Slide the wheel to be mounted onto the
centring pin and push it on.
X
Tighten the wheel bolts until they are fin-
ger-tight.
X
Unscrew the centring pin.
X
Tighten the last wheel bolt until it is finger-
tight.
Lowering the vehicle
G WARNING
The wheels could work loose if the wheel nuts
and bolts are not tightened to the specified
tightening torque. There is a risk of accident.
Have the tightening torque immediately
checked at a qualified specialist workshop
after a wheel is changed.
X
Place the ratchet ring spanner onto the
hexagon nut of the jack so that the letters
AB are visible.
X
Turn the ratchet ring spanner until the vehi-
cle is once again standing firmly on the
ground.
X
Place the jack to one side.
X
Tighten the wheel bolts evenly in a cross-
wise pattern in the sequence indicated ( :
to A ). The tightening torque must be
150 Nm.
X
Turn the jack back to its initial position.
X
Stow the jack and the rest of the tyre-
change tool kit in the boot again.
X
Check the air pressure of the newly fitted
wheel and adjust accordingly.
Observe the recommended tyre pressure
(
Y
page 380).
i
Vehicles with a tyre pressure control sys-
tem: all fitted wheels must be equipped
with functioning sensors for the tyre pres-
sure control system.
Wheel and tyre combinations
General notes
!
For safety reasons, Mercedes-Benz rec-
ommends that you only use tyres and
wheels which have been approved by
Mercedes-Benz specifically for your vehi-
cle.
These are specially adapted to the control
systems, such as ABS or ESP
®
and are
marked as follows:
R
MO = Mercedes-Benz Original
R
MOE = Mercedes-Benz Original Extended
(tyres featuring run-flat characteristics)
R
MO1 = Mercedes-Benz Original (only cer-
tain AMG tyres)
Mercedes-Benz Original Extended tyres
may only be used on wheels that have been
specifically approved by Mercedes-Benz.
Only use tyres, wheels or accessories tes-
ted and approved by Mercedes-Benz. Cer-
tain characteristics, e.g. handling, vehicle
noise emissions or fuel consumption, may
otherwise be adversely affected. In addi-
tion, when driving with a load, tyre dimen-
sion variations could cause the tyres to
come into contact with the bodywork and
axle components. This could result in dam-
age to the tyres or the vehicle.
Mercedes-Benz accepts no liability for
damage resulting from the use of tyres,
wheels or accessories other than those tes-
ted and approved.
Wheel and tyre combinations
391
Wh
eels
and
ty
re
s
Z