Mercedes-Benz S-Class Coupe, Руководство пользователя

Страница: 359 / 413

C
Jack
D
Centring pin
The tyre-change tool kit is kept in a tray in the
stowage well under the boot floor.
In vehicles with a diesel engine, the tyre-
change tool kit is located in the tool bag in the
boot. The tool bag is secured to the boot floor
by Velcro fasteners.
X
Open the boot lid.
X
Swing the boot floor upwards (
Y
page 319)
or detach the tool bag Velcro fasteners.
Flat tyre
Preparing the vehicle
Your vehicle may be equipped with:
R
tyres with run-flat characteristics
(MOExtended tyres) (
Y
page 356)
Vehicle preparation is not necessary on
vehicles with MOExtended tyres.
R
a TIREFIT kit (
Y
page 355)
Information on changing/fitting a wheel
(
Y
page 385).
X
Stop the vehicle as far away as possible
from traffic on solid, non-slippery and level
ground.
X
Switch on the hazard warning lamps.
X
Secure the vehicle against rolling away
(
Y
page 178).
X
If possible, bring the front wheels into the
straight-ahead position.
X
Switch off the engine.
X
Open the driver's door.
The on-board electronics now have status
0. This is the same as the key having been
removed.
X
Remove the Start/Stop button from the
ignition lock (
Y
page 159).
or, if the key is inserted in the ignition lock:
X
Remove the key from the ignition lock.
X
All occupants must get out of the vehicle.
Make sure that they are not endangered as
they do so.
X
Make sure that no one is near the danger
area while a wheel is being changed. Any-
one who is not directly assisting in the
wheel change should, for example, stand
behind the barrier.
X
Get out of the vehicle. Pay attention to traf-
fic conditions when doing so.
X
Close the driver's door.
X
Place the warning triangle a suitable dis-
tance away (
Y
page 354). Observe legal
requirements.
MOExtended tyres (tyres with run-flat
characteristics)
General notes
With MOExtended tyres (tyres with run-flat
characteristics), you can continue to drive
your vehicle even if there is a total loss of
pressure in one or more tyres. The affected
tyre must not show any clearly visible dam-
age.
You can recognise MOExtended tyres by the
MOExtended marking which appears on the
tyre wall. You will find this marking next to the
tyre size designation, the load-bearing capa-
city and the speed index.
MOExtended tyres may only be used in con-
junction with an active tyre pressure loss
warning system or tyre pressure monitoring
system.
If the pressure loss warning message
appears in the multifunction display:
R
observe the instructions in the display mes-
sages (
Y
page 293).
R
check the tyre for damage.
R
if driving on, observe the following notes.
The maximum driving distance is approx-
imately 80 km when the vehicle is partially
laden and approximately 30 km when the
vehicle is fully laden.
356
Flat tyre
Br
eak
down
ass
ist
ance