Mercedes-Benz S 560 4MATIC, Руководство оператора

Страница: 340 / 506

#
Ensure there is sufficient ground clear‐
ance between the underbody and the
guide rails of the car wash.
#
Ensure that the clearance width of the
car wash, in particular the width of the
guide rails, is sufficient.
To avoid damage to your vehicle when using a
car wash, ensure the following beforehand:
R
Active Distance Assist DISTRONIC and the
HOLD function are deactivated.
R
The surround view camera or the rear view
camera is switched off.
R
The side windows and sliding sunroof are
completely closed.
R
The blower for the ventilation/heating is
switched off.
R
The windshield wiper switch is in position
g .
R
The SmartKey is at a distance of at least
10 ft (3 m) away from the vehicle, otherwise
the trunk lid could open unintentionally.
R
In car washes with a conveyor system: neu‐
tral i is engaged.
% In car washes with a conveyor system: if you
would like to leave the vehicle while it is
being washed, make sure the SmartKey is
located in the vehicle. The park position j
is otherwise automatically engaged.
% If, after the car wash, you remove the wax
from the windshield and wiper rubbers, this
will prevent smearing and reduce wiper
noise.
Notes on using a power washer
&
WARNING Risk of an accident when
using power washers with round-spray
nozzles
The water jet can cause externally invisible
damage.
Components damaged in this way may unex‐
pectedly fail.
#
Do not use a power washer with round-
spray nozzles.
#
Have damaged tires or chassis parts
replaced immediately.
To avoid damage to your vehicle, observe the fol‐
lowing when using a power washer:
R
Keep the SmartKey at least 10 ft (3 m) away
from the vehicle. Otherwise the trunk lid
could open unintentionally.
R
Maintain a distance of at least 11.8 in
(30 cm) to the vehicle.
R
Vehicles with decorative foil: parts of your
vehicle are covered with a decorative foil.
Maintain a distance of at least 27.6 in
(70 cm) between the foil-covered parts of the
vehicle and the nozzle of the power washer.
Move the power washer nozzle around whilst
cleaning. The water temperature of the
power washer must not exceed 140 °F
(60 °C).
R
Observe the information on the correct dis‐
tance in the equipment manufacturer's oper‐
ating instructions.
338 Maintenance and care