Mercedes-Benz 2016 Metris, Руководство оператора

Страница: 177 / 310

message with 3 , the display shows the next
submenu.
X
Press f or g to activate or deactivate ESP.
X
Press 3 to confirm.
The next submenu is shown in the display.
If the å warning lamp in the instrument
cluster lights up when the vehicle is ready to
drive, ESP
®
is deactivated.
Observe the information on warning lamps
(
Y
page 222) and display messages
(
Y
page 194).
Setting the sensitivity of the rain sensor
The vehicle must be stationary. Use the buttons
in the instrument cluster.
X
Press È to select the Settings Settings menu.
X
Press 3 to select the Rain Sensor Rain Sensor sub-
menu.
The display shows the current sensitivity set-
ting.
X
Press f or g to select the Low Low , Standard Standard or
Sensitive Sensitive setting. This setting controls the
rain sensor's sensitivity to precipitation. The
windshield wiper will then wipe more or less
frequently at the same precipitation intensity.
X
Press 3 to confirm.
The next submenu is shown in the display.
You can find further information under "Wind-
shield wiper" (
Y
page 103).
Activating/deactivating ATTENTION
ASSIST
The vehicle must be stationary. Use the buttons
in the instrument cluster.
X
Press È to select the Settings Settings menu.
X
Press 3 to select the Attention Assist Attention Assist
submenu.
The display shows the current status.
If the Attention Assist Inoperative Attention Assist Inoperative
message is shown in the display, ATTENTION
ASSIST is not available due to a malfunction
and is deactivated. If you confirm the mes-
sage with 3 , the display shows the next sub-
menu.
X
Press f or g to activate or deactivate
ATTENTION ASSIST.
X
Press 3 to confirm.
The next submenu is shown in the display.
Further information can be found under "ATTEN-
TION ASSIST" (
Y
page 150).
Selecting the permanent display func-
tion
With the Permanent Display: Permanent Display: function, you
can switch the display in the header between
outside temperature and speed.
If the display shows the speed in the header, the
outside temperature is shown with the odome-
ters (
Y
page 172).
The additional speedometer unit in the header is
always inverse to the speedometer unit.
The vehicle must be stationary. Use the buttons
in the instrument cluster.
X
Using È select the Settings Settings menu.
X
Using 3 select the Permanent Display: Permanent Display:
submenu.
The display indicates the selected setting of
Outside Temp. Outside Temp. or Speedometer Speedometer .
X
Change the setting by pressing f or g .
X
Press 3 to confirm.
The next submenu is shown in the display.
Selecting the unit for the distance
In the Distance Unit: Distance Unit: submenu, you can
select whether the display shows certain infor-
mation in kilometers or miles.
The vehicle must be stationary. Use the buttons
in the instrument cluster.
X
Press È to select the Settings Settings menu.
X
Press 3 to select the Distance Unit: Distance Unit: sub-
menu.
The display indicates the selected setting of
km km or Miles Miles .
X
Change the setting by pressing f or g .
X
Press 3 to confirm.
The display shows the next submenu or the
Settings Settings menu again.
The selected distance units are used for the dis-
plays:
R
Digital speedometer
R
Odometer and trip odometer
R
Trip computer
R
Range
R
Current consumption
R
Cruise control
R
Service intervals
On-board computer (vehicles without steering wheel buttons)
175
On-bo
ard
co
mput
er
and
displays
Z