Mercedes-Benz 2015 GLK, Руководство оператора

Страница: 235 / 316

transmitter button
B
on the garage door
remote control.
X
Repeat the programming procedure. When
doing so, vary the distance between the
garage door's remote control and the
transmitter buttons in the rear-view mirror.
i If the garage door system works with a
rolling code, you must synchronize the
remote control integrated in the rear-view
mirror with the garage door system
receiver after programming.
You will find further information in the
garage door opening system's operating
instructions, e.g. the sections on
"Synchronizing the transmitter" or
"Registering a new transmitter". You can
also call the hotline mentioned above.
Notes on programming the remote
control
Canadian radio frequency laws require a
"break" (or interruption) of the transmission
signals after broadcasting for a few seconds.
Therefore, these signals may not last long
enough for the integrated remote control to
recognize the signal during programming.
Comparable with Canadian law, some U.S.
garage door openers also have a built-in
"interruption".
If you live in Canada or have difficulties
programming the garage door opener
(regardless of where you live) when using the
programming steps (see above), proceed as
follows:
X
Press transmitter button (
;
,
=
or
?
) and
hold it down during the following steps until
the setup has been completed
successfully.
X
At the same time, press transmitter button
B
of the garage door remote control for
two seconds, then release it for two
seconds, then press it again for two
seconds.
X
Repeat this sequence on transmitter
button
B
of the garage door remote
control until the frequency signal has been
saved.
X
If the setup procedure is successful,
indicator lamp
:
flashes once slowly and
goes out after a few seconds.
X
Continue with the other programming
steps (see above).
Problems when programming
If you have problems when programming the
integrated remote control, please note the
following:
R
check the transmitter frequency of garage
door remote control
A
(which can usually
be found on the rear of the remote control).
The integrated remote control is
compatible with devices that operate at
frequencies between 280 and 390 MHz.
R
replace the batteries in garage door remote
control
A
. This increases the likelihood of
garage door remote control
A
sending a
strong and precise signal to the integrated
remote control in the rear-view mirror.
R
when programming, hold garage door
remote control
A
at varying distances and
angles from the transmitter button which
you are programming. Try different angles
at a distance between 2 and 12 inches (5
to 30 cm) or the same angle at varying
distances.
R
if there is another garage door remote
control for the same garage door drive,
perform the programming steps again
using that remote control. Before
performing these steps, make sure that
new batteries have been inserted in the
garage door remote control.
R
align the antenna cable of the garage door
opener unit. This can improve signal
reception/transmission.
Opening/closing the garage door
Once programmed, the integrated remote
control will assume the function of the garage
door system's remote control. Please also
Features
233
Stowing and features
Z