Mercedes-Benz 2015 GLK, Руководство оператора

Страница: 155 / 316

Making adjustments in 5 mph (Canada:
10 km/h) increments
X
Briefly press the cruise control lever
beyond the pressure point, up
:
for a
higher speed or down
;
for a lower speed.
The last speed stored is increased or
reduced.
Deactivating cruise control
There are several ways to deactivate cruise
control:
X
Briefly press the cruise control lever
forwards
=
.
or
X
Brake.
Cruise control is automatically deactivated if:
R
you depress the parking brake.
R
you are driving below 20 mph (30 km/h).
R
ESP
®
intervenes or you deactivate ESP
®
.
R
you shift the transmission to position N
while driving.
If cruise control is deactivated, you will hear
a warning tone. You will see the
Cruise
Control Off
message in the multifunction
display for approximately five seconds.
i
The last speed stored is cleared when you
switch off the engine.
4MATIC (permanent four-wheel drive)
4MATIC ensures that all four wheels are
permanently driven. Together with ESP
®
and
ETS, it improves the traction of your vehicle
whenever a drive wheel spins due to
insufficient grip.
G
WARNING
If a drive wheel is spinning due to insufficient
traction:
R
While driving off, apply as little throttle as
possible.
R
While driving, ease up on the accelerator
pedal.
R
Adapt your speed and driving style to the
prevailing road conditions.
Failure to observe these guidelines could
cause the vehicle to skid.
The 4MATIC cannot prevent accidents
resulting from excessive speed.
! Never tow the vehicle with one axle
raised. This may damage the transfer case.
Damage of this sort is not covered by the
Mercedes-Benz Limited Warranty. All
wheels must remain either on the ground
or be fully raised. Observe the instructions
for towing the vehicle with all wheels in full
contact with the ground.
i
In wintry driving conditions, the maximum
effect of 4MATIC can only be achieved if
you use winter tires (M+S tires), with snow
chains if necessary.
! When testing the parking brake, operate
the vehicle only briefly (for a maximum of
ten seconds) on a brake test dynamometer.
When doing this, turn the SmartKey to
position
0 or 1 in the ignition. Failure to do
this can cause damage to the drive train or
the brake system.
! Function or performance tests may only
be performed on a 2-axle dynamometer. If
you wish to operate the vehicle on such a
dynamometer, please consult an
authorized Mercedes-Benz Center
beforehand. You could otherwise damage
the drive train or the brake system.
Driving systems
153
Driving and parking
Z