Mercedes-Benz 2014 G-Class, Руководство оператора

Страница: 198 / 272

objects are present within the sweep of the
door or gate.
Observe the safety notes when performing
the rolling code synchronization
(
Y
page 193).
X
Turn the SmartKey to position
2(
Y
page 97) in the ignition lock.
X
Press the programming button of the door
or gate drive (see the door or gate drive
operating instructions, e.g. under
"Programming of additional remote
controls").
i
Usually, you now have 30 seconds to
initiate the next step.
X
Press previously programmed button ; ,
= or ? of the integrated garage door
opener until the door closes.
The rolling code synchronization is then
complete.
Notes on programming the remote
control
Canadian radio frequency laws require a
"break" (or interruption) of the transmission
signals after broadcasting for a few seconds.
Therefore, these signals may not last long
enough for the integrated remote control to
recognize the signal during programming.
Comparable with Canadian law, American
garage door openers also have a built-in
"interruption".
If you live in Canada or have difficulties
programming the garage door opener
(regardless of where you live) when using the
programming steps, proceed as follows:
Integrated remote control in the rear-view mirror
:
Indicator lamp
;=?
Transmitter buttons
A
Garage door remote control
B
Transmitter button on the garage
door remote control
X
Keep the transmitter button ( ; , = or ? )
depressed until the integrated remote
control has been set up successfully.
X
At the same time, press transmitter button
B of the garage door remote control for
two seconds, then release it for two
seconds, then press it again for two
seconds.
X
Repeat this sequence on transmitter
button B of the garage door remote
control until the frequency signal has been
saved.
X
If the setup procedure is successful,
indicator lamp : flashes once slowly and
goes out after a few seconds.
X
Continue with the other programming
steps (see above).
196
Features
Stowage
and
features