buttons, you must first switch off the Night
View Assist.
:
Night View Assist image
;
Speedometer dial
Adjusting instrument cluster illumination
If you change the brightness of the
instrument cluster while the Night View
Assist is switched on, only the brightness of
the multifunction display is changed.
X
Make sure the Night View Assist is
switched on.
X
Brightening illumination: Turn knob
:
clockwise.
X
Dimming illumination: Turn knob
:
counterclockwise.
Dirty or fogged-up windshield
The Night View Assist image is diminished
when the windshield in front of the camera is
R
dirty
R
fogged up on the outside
R
fogged up on the inside
G
Warning!
Please do not forget that your primary
responsibility is to drive the vehicle. A driver’s
attention to the road must always be his/her
primary focus when driving. For your safety
and the safety of others, stop before trying to
remove window fogging or cleaning the
windshield in front of the Night View Assist
camera.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet
(approximately 14 m) every second.
X
Removing condensation: Check settings
of the climate control and change them, if
necessary (
Y
page 338).
X
Swing the camera cover downward
(
Y
page 407).
X
Cleaning inside of windshield: Use a soft,
non-scratching cloth (
Y
page 407).
Blind Spot Assist
The Blind Spot Assist uses radar sensors to
monitor the area on both sides of your
vehicle. It will assist you when you change
lanes driving at speeds of above 20 mph
(30 km/h). A red warning lamp will come on
in the exterior rear view mirror as soon as
another vehicle is detected. If you then
activate the corresponding turn signals to
change lanes, the red warning lamp flashes
and warning sounds (collision warning). The
Blind Spot Assist operates using two sensors
in the front bumper and four sensors in the
rear bumper.
Driving systems
335
Controls in detail
216_AKB; 3; 90, en-US
d2ureepe,
Version: 2.11.8.1
2009-05-15T11:47:50+02:00 - Seite 335
Z
