Mercedes-Benz 2008 SLK-Class, Руководство пользователя

Страница: 235 / 273

Battery
232
X
Remove water tank 1 .
X
Remove the negative terminal clamp from
the battery.
X
Remove the cover from the positive termi-
nal clamp.
X
Remove the positive terminal clamp from
the battery.
X
Disconnect the breather hose.
Removing the battery
X
Disconnect the battery (
Y
page 231).
X
Loosen the bolt which holds the battery in
place.
X
Remove the battery.
Charging and fitting the battery
G Risk of injury
Only charge the installed battery with a bat-
tery charger which has been tested and
approved by Mercedes-Benz. These battery
chargers allow the battery to be charged
while it is still installed. Otherwise, the vehi-
cle's electronic system may be damaged.
Only charge the battery in a well-ventilated
area. As the battery is being charged, gases
can escape and generate minor explosions.
This may injure you and other persons or
cause damage to the paintwork or acid cor-
rosion on the vehicle.
You can obtain information about battery
chargers which allow the battery to be
charged when still installed from a qualified
specialist workshop, e.g. a Mercedes-Benz
Service Centre.
G
Risk of injury
There is a risk of acid burns during the
charging process due to the gases which
escape from the battery. Do not lean over
the battery during the charging process.
!
Only use battery chargers with a maxi-
mum charging voltage of 14.8 V.
X
Charge the battery. Observe the notes in
the operating instructions for your battery
charger.
X
Refit the charged battery.
To do this, follow the steps described in
"Removing the battery" (
Y
page 232) in
reverse order.
G
Risk of injury
Battery acid is caustic. Avoid contact with
the skin, eyes or clothing.
Reconnecting the battery
!
Always reconnect the battery in the
sequence described below. Never swap the
terminal clamps. You may otherwise dam-
age the vehicle electronics.
X
Switch off all electrical consumers.
X
Connect the positive terminal clamp and
secure the cover.
X
Connect the negative terminal clamp.
X
Connect the breather hose. Make sure that
a cell cap is fitted between the battery and
the breather hose.
Practical advice
171_AKB; 3; 4, en-GB
vpfaff7,
2007-11-13T10:50:25+01:00 - Seite 232