A. Preparing for the installation
1. Read these installation instructions in their
entirety before beginning.
2. Unpack and compare the installation kit
contents against the Parts Information list—
Section M.
3. Place the operating guides and customer
accessories in the glove box or appropriate
stowage compartment.
4. Remove the bottom, center trunk paneling,
and dismount the equipment carrier.
•
Refer to WIS document AR68.30-P-
4810V, “Remove/install center trunk
paneling”
5. Lay down the equipment carrier on its
backside to expose the attached components
on its front (Figure 1).
Figure 1
P82.70-xxxx-71
Note:
If the vehicle is Car Navigation processor equipped, carefully cut the wire tie securing the
equipment carrier to the Car Navigation compartment.
B. Locating and identifying the cables
1. On the right side of the equipment carrier,
carefully cut the wire ties bundling the
telephone cables to the wiring harness
running along the Tele Aid control module,
and then separate and lay out (Figure 2) the
cable connectors for identification.
Figure 2
P82.70-xxxx-71
PRELIMINARY DRAFT
November 2004
2
