10. Remove the female FAKRA and power
supply connectors from the clips in the
housing at the bottom of the upper
compartment of the center console.
11. Connect the male FAKRA connector (A,
Figure 27) of the contact plate to the female
FAKRA connector (B, Figure 27) in the
housing.
12. Connect the male power supply connector
(C, Figure 27) from the contact plate to the
female power supply connector (D, Figure
27) in the housing.
13. Reinstall the coupled connectors into their
respective clips in the housing and close the
housing cover for the FAKRA and power
supply connectors.
Figure 27
P82.70-xxxx-71
14. Reinstall the false floor with mounted
contact plate (Figure 28) with the previously
removed four T8 Torx screws.
15. Attach the cradle—according to telephone
type—to the contact plate by placing it atop
and slightly behind the contact plate and
then sliding it forward until an audible click
sounds.
16. Insert the telephone into the cradle.
Figure 28
P82.70-xxxx-71
I. Installing the fuse at the rear SAM
1. On the left side of the equipment carrier,
find the rear SAM fuse and relay panel and
insert the 7.5 amp fuse in slot #3 (Figure
29).
Figure 29
P82.70-xxxx-71
PRELIMINARY DRAFT
November 2004
12
