Merax MS199736, Руководство пользователя

Страница: 42 / 45

3DJH
9
First, connect the (53) on the sensor line with (46)
below the sensor line, then connect the heart rate
line of front post (80) with the heart rate line of
front main frame (79).
See graph A. Pull up the metal bracket (B) on the
fine-tuning line (82), then insert the end of fine-
tuning line (52) into the harness clip of metal
bracket.
See graph B. Pull up the fine-tuning line (52) and
slide it into the top of metal bracket (B), as dotted
line shown.
See graph C. Pinch the prong at the upper end
of the metal bracket (B) together with the plier,
subject to the home condition.
Finally, plug the wire harness and the excess
cable into the front main frame (1).
10
Insert the front post (2) into the front main frame
(1) with three M8*16mm (40), spring washers M8
(83) and arc washers M8 (42). Do not tighten the
screws.
See the illustration in the lower right corner.
Insert two hexagon socket head cap screws
M8*65mm (41) and arc washers M8 (42) into the
front main frame from left to right and front to back,
then put two arc washers M8 (42) and spring
washers (83). Connect the front post with lock
nuts M8 (60). Lock all screws after the front post
is in line with main workshop.
42
EN