Step 3 M piece installation
Putting the M piece (44R) through the pedal core shaft (75) of the platform (59) parts, and fixing the M piece (44R) on the
pedal core shaft (75) with the inner hexagon screw (10), cushions (11) and gasket (40). Screwing with an Allen wrench (99).
(Note that the M pieces are divided into left (L) and right (R), which are marked on the package)
Step 4 Installation of center shaft and lower swing
Firstly, installing the pre-assembled (34R) + (25R) on the handlebar stand pipe (30) (firstly installing the position shown in
the figure below), then successively penetrating into the lower swing (25R) with the central shaft (21), after that, putting
them into the spring washer (16), penetrating into the handlebar stand pipe(30), the details are shown in the corresponding
position. The other side can be installed as above. Finally, the two ends of the central shaft (21) are fixed with screws (10),
cushions (11) and spring washers(12), fastening with two inner allen wrench(99).
STEP 3
44L
11
40
10
59
75
44R
40 11
10
STEP 4
21
10
11
12
16
34R
25L
25R
34L
30
44R
44L
59
12
11
10
16
9
